Flash rom using Smart Phone Flash Tool (SP flash tool)

Hi,

If you are a frequent rom changer, no need to tell you the ways in which rom can be flashed. Either through custom recovery (mobile method) or through Smart Phone Flash Tool (PC method).
This post is intended at newbies who need a guide to flash rom through Smart Phone Flash Tool.

It is good to disable anti-virus solution if any in your PC before doing this because it may block flash tool opening attempt sometimes.

Requirements :

Unite2 device

Stock Rom of Unite2  (extract it)

PC

Smart Phone Flash Tool   link to download :sp flash tool 

Compatible USB cable

Connect your Unite2 to PC through USB cable and let it install the software.  Now unzip SPFT. Run flash tool exe as 'run as administrator'.

Now  you can see a 'scatter loading' button at the top right side.  Click on it.  You will be asked to select the location.  Select the 'MT6582 scatter file' txt  which can be seen in the extracted Stock Rom zip.  Select it.  Now you can see that all the first column items in the flash tool box are ticked. Make sure that location column of each item is not left empty.

Now select firmware upgrade option from the drop down menu
Switch off your device, remove battery.
Connect USB cable to the PC port. Not connect device now. wait....

Now click on download in the flash tool. Then connect device to the cable.
Flashing process begins now.  You can see the progress at the bottom.

When the flashing completes, you can see a green tick mark on the flash tool screen.

Now detach device from USB cable, insert battery and switch it on.  It will take some minutes to boot. So wait.
Done.

Note:  If you want to flash a custom recovery,  do the following just after flashing the rom

Download your required recovery (CTR, CWM, etc)
Disconnect phone from PC.
Untick all the boxes except recovery column.  Click on the location column of recovery and select the recovery file from where you have kept it.
Select download option from the drop down menu.  Click on 'download' button at the top.
Now connect phone through USB.
Just as in rom flashing, you can see the progress bar below and a tick mark at the end of flashing.

Done. Disconnect the phone and restart.